PSU UV Cover & Fan
This Mod is being done to an Antec 400SL and it is already sleeved with UV reactive Blue sleeving and Red Heat Shrink, Along with UV ConnectRight Molex & Terminals connectors.
Above is the UV Cover from FrozenCPU.com and 2 fans one Antec 92mm Case Fan a 80mm Tri LED Fan.
Step one is to take off original cover to PSU note that with many PSU units this voids the warranty so you are doing this mod at your own risk..
Next remove the fans from the case and unhook the fan from the terminal .
Cut the wires from the terminal and from 80mm fan.
Strip the wires and place the heat shrink tubing on one side of the spliced wire.
Twist the wires together and with a soldering iron fuse the 2 wires together.
Slide the heat shrink over the exposed wire and using a heat gun or a lighter apply heat to the heat shrink.
Place the terminals back after fusing all the wires on both the 80mm and 92mm fans
Place the grills and the fans back in the PSU covers and fasten tightly
As you can see I am using gaskets and longer screws on the Acrylic UV cover this is to reduce noise and scratching on the acrylic itself.
Apply the 2 sided tape and zip up lose wiring from the fans.
And there it is all done.
Other Good Links
Mod Sites & Guides
12-23-04 reLANtless Dec. LAN Party Photos
11-24-04 CD Stealth Mod By Jess
10-23-04 Red CCFL Fan Kit Review
10-14-04 Corsair XLPro XMS3200 Benchmark Results
10 -04-04 ATI RADEON 9600 XT 128 Meg
09-30-04ATI Comparison 9100Pro Vs. 9600XT 3DMark200l & 3DMark03
09-27-04ProLink GeForce FX 5700 LE 256Meg card
09-22-04Message Board Check it Out!!!
09-19-04ThermalRight NB-1C Chip Set Cooler
09-17-04FrozenCPU UV Reactive PSU Covers
09-16-04Pololu Custom Acrylic Grills all Laser Cut
09-14-2004ProLink GeForce FX 5700 LE 256Meg DDR Benchmarks 3DMark03
09-01-2004Project Sound Wave Website updated
08-25 2004Started A Linux server Project Blue Drake
Copyright © 2004 Marns
Want to Be an Affiliate? Click